Embed Square Solutions
Industries · Automotive & EV

Automotive hardware that passes the second time, the first time

ECUs, traction controllers, body electronics and the test infrastructure behind them — engineered against the standards that fail a design late, when a change costs a quarter instead of a week.

Standards that decide the design

  • CISPR 25
  • ISO 11452-2
  • ISO 7637-2
  • ISO 16750-2

What we build for automotive

Sensorless FOC motor controllers for traction and pumps. Engine and body ECUs with CAN 2.0A/B and LIN. Gateways between vehicle buses and test networks. Charging control for AC and DC platforms. And the test cells themselves — ISO 7637-2 and ISO 16750-2 benches used by tier-1 suppliers to qualify the parts that go into the vehicle.

The four standards that decide the design

CISPR 25 governs what the component may emit. ISO 11452-2 governs what it must survive in an absorber-lined chamber. ISO 7637-2 governs the switching transients on the supply line. ISO 16750-2 governs the electrical loads — load dump, cranking, reverse polarity. A layout decision that ignores any one of them is a redesign later.

StandardWhat it testsWhere it lands in the design
CISPR 25Conducted and radiated emission, 150 kHz – 2.5 GHzSwitching edges, filtering, shielding, PCB return paths
ISO 11452-2Radiated immunity in an ALSE, field strengths by classHarness routing, enclosure seams, filter placement
ISO 7637-2Conducted transients on 12 V / 24 V supply lines, pulses 1–5Front-end clamp, TVS selection, bulk capacitance
ISO 16750-2Electrical loads: load dump, cranking, reverse polarityInput protection window, hold-up, inrush